Welcome to the Atrix Forum - Motorola Atrix Forum.

Register ButtonIf this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed.

AT&T Motorola Atrix 4G (MB860) soft bricked!

This is a discussion on AT&T Motorola Atrix 4G (MB860) soft bricked! within the Motorola Atrix Hacks forums, part of the Motorola Atrix Development category; Hi, I have an AT&T Motorola Atrix 4G (MB860) that Iíve just recently unlocked (the moto logo says it J ) and rooted (adb shell ...

Page 1 of 2 12 LastLast
Results 1 to 10 of 17
Like Tree3Likes

Thread: AT&T Motorola Atrix 4G (MB860) soft bricked!

  1. #1
    Junior Member
    Member #
    17327
    Join Date
    Nov 2013
    Posts
    11
    Liked
    0 times

    AT&T Motorola Atrix 4G (MB860) soft bricked!

    Hi,
    I have an AT&T Motorola Atrix 4G (MB860) that Iíve just recently unlocked (the moto logo says it J) and rooted (adb shell opens a # prompt) using unlock_v4.2. Previously this mobile was up to date on Ginger Bread 2.3.6 and firmware 4.5.145. I also installed CWM 4.1.0.4 using unlock_v4.2 and finally cm-7.2.0-olympus to test that everything works fine (my final goal is cm10.2). btw, I cleaned up data, cache and dalvik before rebooting. Unfortunately Iím soft bricked. I tried all the different sbf files of unlock_4.2 (4547-fix-try2, pudding and trololol-unlock234) with no success. I also tried CWM 5.0.2.0 and recovery-en-goapk-0630-1029 but no success either. To be fair I didnít test all combinations of different sbf and CWMs but tried a few. I donít know what else I can do. Any pointer to resolution?


  2. #2
    Junior Member
    Member #
    17327
    Join Date
    Nov 2013
    Posts
    11
    Liked
    0 times
    Btw, RSD Lite now logs the following errors:

    11/24/13 17:12:38 New Log Started For Software Download.
    11/24/13 17:12:38 The FlashLog key is turned off.
    11/24/13 17:12:40 0000041c Phone.cpp 464 0 ERROR Generic failure when sending command.
    11/24/13 17:12:40 0000041c Phone.cpp 1601 0 ERROR GetPhoneID failed: ERROR.
    11/24/13 17:12:46 0000041c Phone.cpp 464 0 ERROR Generic failure when sending command.
    11/24/13 17:12:46 0000041c Phone.cpp 1601 0 ERROR GetPhoneID failed: ERROR.
    11/24/13 17:12:48 0000041c Phone.cpp 464 0 ERROR Generic failure when sending command.
    11/24/13 17:12:48 0000041c Phone.cpp 1601 0 ERROR GetPhoneID failed: ERROR.
    11/24/13 17:12:48 0000041c Phone.cpp 464 0 ERROR Generic failure when sending command.
    11/24/13 17:12:48 0000041c Phone.cpp 1696 0 ERROR GetTechnology failed: ERROR.
    11/24/13 17:12:48 0000041c Phone.cpp 464 0 ERROR Generic failure when sending command.
    11/24/13 17:12:48 0000041c Phone.cpp 1764 0 ERROR GetSoftwareVersion failed: SendTC failed: ERROR.
    11/24/13 17:12:48 0000041c Phone.cpp 464 0 ERROR Generic failure when sending command.
    11/24/13 17:12:48 0000041c Phone.cpp 1922 0 ERROR GetSoftwareFlexVersion failed: ReadSeemElement failed: ERROR.
    11/24/13 17:12:48 0000041c Phone.cpp 464 0 ERROR Generic failure when sending command.
    11/24/13 17:12:48 0000041c Phone.cpp 1811 0 ERROR GetDRMVersion failed: SendTC failed: ERROR.
    11/24/13 17:12:48 Multi upgrade started for 1 phones
    11/24/13 17:12:48 [Device ID: 0] Flashing phone.
    11/24/13 17:17:49 Multi upgrade finished.

  3. #3
    Super Moderator
    Member #
    8495
    Join Date
    Nov 2011
    Posts
    1,920
    Liked
    495 times
    Quote Originally Posted by mulargui View Post
    Hi,
    I have an AT&T Motorola Atrix 4G (MB860) that I’ve just recently unlocked (the moto logo says it J) and rooted (adb shell opens a # prompt) using unlock_v4.2. Previously this mobile was up to date on Ginger Bread 2.3.6 and firmware 4.5.145. I also installed CWM 4.1.0.4 using unlock_v4.2 and finally cm-7.2.0-olympus to test that everything works fine (my final goal is cm10.2). btw, I cleaned up data, cache and dalvik before rebooting. Unfortunately I’m soft bricked. I tried all the different sbf files of unlock_4.2 (4547-fix-try2, pudding and trololol-unlock234) with no success. I also tried CWM 5.0.2.0 and recovery-en-goapk-0630-1029 but no success either. To be fair I didn’t test all combinations of different sbf and CWMs but tried a few. I don’t know what else I can do. Any pointer to resolution?
    If I understand you right, you took the following procedures:

    -Unlocked your phone
    -Installed custom recovery
    -Flashed a custom rom
    -Cleared data, cache, and dalvik before rebooting
    -You were softbricked (I am guessing it was bootlooping?)

    This is where I am confused, where you say that you tried sbf files to unlock again and attempted to install another custom recovery. At this point are you able to boot into recovery?

    It sounds like in your second post you attempted to flash back to stock? Is your phone giving you any error code when you attempt to power on/reboot?

  4. #4
    Junior Member
    Member #
    17327
    Join Date
    Nov 2013
    Posts
    11
    Liked
    0 times
    Thank you for replying.
    Right, I did all the steps you mentioned and I ended up soft bricked. Later I tried several .sbf to solve the problem with no success. I also read online that it might be the version of cwm the cause of not booting the ROM and tried a couple of other versions, no success again. The errors that you are seeing where logged installing pudding.sbf, and I also got the same errors trying to install trololol-unlock234.sbf.
    I can boot into recovery, fastboot, rsd or any other of the boot menu items, but I cannot boot a rom or charge the battery (I recharged it using a USB cable). I didn't try yet to flash back to stock, I don't want to give up so early. I'm running out of ideas, any suggestion?

  5. #5
    Super Moderator
    Member #
    8495
    Join Date
    Nov 2011
    Posts
    1,920
    Liked
    495 times
    When you turn on your phone, what exactly do you see on your splash screen (the initial screen/logo you see when you boot up your phone). Also, does the phone move past the splash screen (does the boot animation come on)?

  6. #6
    Junior Member
    Member #
    17327
    Join Date
    Nov 2013
    Posts
    11
    Liked
    0 times
    I just get the motorola logo with the text dual core technology in the middle and unlocked in the left top corner. Nothing else happens

  7. #7
    Junior Member
    Member #
    17327
    Join Date
    Nov 2013
    Posts
    11
    Liked
    0 times
    And no light turns on (the diode at the top)

  8. #8
    Super Moderator
    Member #
    8495
    Join Date
    Nov 2011
    Posts
    1,920
    Liked
    495 times
    That is odd. The only option I can see without flashing back to stock is to load a different rom on to your external sd card and attempting to flash through recovery. What bothers me is that you are unable to charge and that you are not getting a bootanimation. Maybe someone else can think of a better alternative.
    Last edited by Condor97; 11-26-2013 at 08:28 PM.

  9. #9
    Junior Member
    Member #
    17327
    Join Date
    Nov 2013
    Posts
    11
    Liked
    0 times
    Thank you for replying. I'm considering flashing back to stock and start from scratch again. During all this reflashings I lost my stock backup. Is there a place to get a 4.5.145 stock rom? Is safe to revert to stock? some people say I'll be hard bricked.

  10. #10
    Super Moderator
    Member #
    1002
    Join Date
    Mar 2011
    Location
    Cleveland, Ohio - The North Coast!
    Posts
    18,231
    Liked
    2018 times
    Condor97 likes this.
    GSM Galaxy Note 3 (Black) - Straight Stock
    GSM Galaxy Note 2 (Titanium) - Rooted running Jedi X20 Rom
    GSM Galaxy Nexus (Black) - Straight Stock

    GSM Samsung Galaxy S3 (Red) - Rooted running Deadly Venom v8.0.1 Rom







 
Page 1 of 2 12 LastLast

Remove Ads

Ads

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Similar Threads

  1. MB860 atrix soft bricked
    By mag1cn1nja in forum Rescue Squad
    Replies: 27
    Last Post: 05-19-2013, 07:18 PM
  2. Atrix 4g , soft bricked , PLEASE help me
    By Br0oKlyN in forum Rescue Squad
    Replies: 2
    Last Post: 06-01-2012, 10:45 PM
  3. Need help with Atrix (Soft-Bricked)
    By JakeAkaGod in forum Rescue Squad
    Replies: 11
    Last Post: 11-19-2011, 10:28 PM
  4. Need help with Atrix (Soft-Bricked)
    By JakeAkaGod in forum Motorola Atrix Hacks
    Replies: 1
    Last Post: 11-19-2011, 04:11 PM
  5. Help with a soft bricked atrix
    By slashmania in forum Motorola Atrix Help
    Replies: 2
    Last Post: 10-15-2011, 06:45 PM

Search tags for this page

atrix 4g bricked adb download
,
atrix 4g olympus install avatar rom jb work fine but mobile data not work
,
atrix 4g us fruitcake cwm flashable
,
atrix cwm can mount sdcard
,
atrix mb860 rom 2014
,
cm 10.1 epinter atrix
,
epinter cm 10.1 olympus download
,
hack brick motorola atrix 2
,
mb860 epinter 2014
,
mb860 rom note3 atrix 4g
,

motorola atrix mb860 olympus rom

,
motorola atrix mb860 rom at&t
,
olympus cm 10.1
,
olympus unofficial cm recovery zip download
,
tell me about the motorola atrix mb860 4g
Click on a term to search for related topics.